23 years old
- Body type:Slim
- Height:5'9 / 163cm
Go to my webcam chat?
There we can have a conversation face to face.
Cum On Breast
Cum In Mouth
How to wire an L-pad
Got a moment? Not sure if there is a certain L-Pad that is best to get or if it matters. I guess that technically together it would be 4 ohms In the power-soaker approach, the power tubes are pushed into their maximum possible power output, and then the unwanted resulting power is directed into the dummy load portion of the power attenuator, which is placed between the output transformer and the guitar speaker, routing only a portion of the output power to the guitar speaker. The first screen you see will say, "Hello.REGISTER TO VIEW
Rock Custom Pinball. Does running the epi at full all the time mean its gonna wear quickly? That or a box of resistors on a rotary switch like most aftermarket attenuators. External Subwoofer Cable. The output is taken from the second resistor which is relatively small and so it represents a low impedance. Other than that, it was a quick, easy and cheap project that performs exactly as expected.REGISTER TO VIEW
Interesting you should mention this. The language you select will be the one the iPad uses for all of its text and directions. No 4 ohm loads on the bridged CS Reply to this topic Start new topic. Reply to this topic Madsci says:.REGISTER TO VIEW
Setting up an iPad For First-Time Use
Hi Madsci I built your L pad tonight and it does work but the input signal is from a police scanner rec out, db i think. And without giving too much away those other atennuators that look like l-pads I am going to install the L-pads right now and will post back with my results.REGISTER TO VIEW REGISTER TO VIEW